DaVinci

Bought 14/10 2016. The printer was easy to set up. Putting the filament in order was different, in that the move ahead mechanism sat on the left upper side of the machine. A little throublesome to bring the filament from the spool through the 'mover' to the extruder. The first attemt of printing was unsuccessful because I did not take of the plastic from the BuildTak (a piece of material to put on the base plate). Then next time (after having calibrated) the printing went quietly and fast. The result was as good as with the Cube.

The software used for slicing is (XYZware)